Filter
Top Products
Quick Start Instructions MultiVOIP User Guide
46
Introduction
This chapter gets the MultiVOIP up and running quickly. The details
we’ve skipped to make this brief can be found elsewhere in the manual
(see Table of Contents and Index).
MultiVOIP Startup Tasks
Tas
k
Summary
z Collecting Phone/IP
Details (vital!)
The MultiVOIP must be configured to
interface with your particular phone
system and IP network. To do so,
certain details must be known about
those phone and IP systems.
z Placement
Decide where you’ll mount the voip.
z Command/Control
Computer Setup:
Specs & Settings
Some modest minimum specifications
must be met. A COM port must be set
up.
z Hookup Connect power, phone, and data cables
per diagram.
z Software Installation This is the configuration program.
It’s a standard Windows software
installation.
z Phone/IP Starter
Configuration
You will enter phone numbers and IP
addresses. You’ll use default parameter
values where possible to get the system
running quickly.
z Phonebook Starter
Configuration
The phonebook is where you specify
how calls will be routed. To get the
system running quickly, you’ll make
phonebooks for just two voip sites.
z Connectivity Test You’ll find out if your voip system can
carry phone calls between two sites.
That means you’re up and running!
z Troubleshooting Detect and remedy any problems that
might have prevented connectivity.