Filter
Top Products
MultiVOIP User Guide Technical Configuration (T1/E1)
139
7. Enable Web Browser GUI (Optional). After an IP address for the
MultiVOIP unit has been established, you can choose to do any further
configuration of the unit (a) by using the MultiVOIP web browser GUI,
or (b) by continuing to use the MultiVOIP Windows GUI. If you want
to do configuration work using the web browser GUI, you must first
enable it. To do so, follow the steps below.
A. Set IP address of MultiVOIP unit using the MultiVOIP
Configuration program (the Windows GUI).
B. Save Setup in Windows GUI.
C. Close Windows GUI.
D. Install Java program from MultiVOIP product CD (required on
first use only).
E. Open web browser.
F. Browse to IP address of MultiVOIP unit.
G. If username and password have been established, enter them
when when prompted.
H. Use web browser GUI to configure or operate MultiVOIP unit.
The configuration screens in the web browser GUI will have the same
content as their counterparts in the Windows GUI; only the graphic
presentation will be different.
For more details on enabling the MultiVOIP web GUI, see the “Web
Browser Interface” section of the Operation & Maintenance chapter of
this manual.