Filter
Top Products
Mitel Networks 5700 VFA End Point’s Guide 9
4CALL FORWARD
The Call Forward function enables the 5700 VFA to forward a call to a specific
user unconditionally, or if the actual destination does not answer, or is busy.
The Call Forward settings for your system may be done by both you and the system
administrator. The last changes, regardless of who made them, are valid.
NOTE When the 5700 VFA is connected to a 3300 ICP (Voice First Mode), you
do not need to program these settings (the 5700 VFA uses the Call
Forward settings of the 3300 ICP).
4.1 Setting Call Forward in MeetingPoint
®
4.6
In MeetingPoint
®
4.6, call forwarding properties for your system may be set in the
System Calls Properties dialog box.
! To set Call Forward
2. In the Forward Destination group, select each forwarding option that you
want to enable. For a description of these options, see “Call Forward
Options” on page 4-11.
In each option’s accompanying box, enter the 5700 VFA directory number
of a user by one of the following methods:
— Type the user’s directory number, IP address, DNS name or E.164
number (when entering an IP address, do not enter leading zeroes).
-or-
— To select a user, click it in the list or click Browse at the end of the
row. In the Select an Entry dialog box, select a user and click OK.
3. In the Forward After box, enter the number of seconds that will pass
before the 5700 VFA forwards the call.
4. Click OK to implement the settings.
1. In MeetingPoint’s Conference Panel, click the Services arrow and
then click Call Forward Properties. The Forward Calls Properties
dialog box appears.