Filter
Top Products
44
REMOTE OPERATION (CONTINUED)
USING THE REMOTE CALL IN
To call in to listen to your messages remotely, change settings, etc, dial the phone
number from a remote phone and follow the instructions below:
1. Listen to or bypass the OGM in the primary mailbox, then enter the Access
Code. If the announcement does not stop, enter the Access Code again.
2. The answering system will request that you enter the Instruction Code or press
the button for help. See the section below for the Instruction Codes. If you do
not have them handy, press the button to hear them.
NOTE: If a command is not received within eight seconds, the answering system
will hang up.
INSTRUCTION CODES
To playback message press “2.”
To repeat message press “1.”
To skip message press “3.”
To stop message press “8.”
To playback announcement press “5.”
To turn answering machine ON or OFF press ”6.”
To erase message press “9.”
To record memo or announcement press “0.”
(To record a message press “2”, to record announcement press “5”.)
(Press “1” for Mailbox 1, press “2” for Mailbox 2, press “3” for Mailbox 3, press “4”
for Mailbox 4, and press “0” for Primary Mailbox. Otherwise, if you did not press the
desired Mailbox # location within 7~8 seconds, the Answering System will
automatically hang up.)
To change mailbox press “#.”
3. Press the corresponding number of the Instruction Code you wish to activate. You
don’t have to listen to the entire Instruction Code Help Menu before giving a
command. You may enter the desired Instruction Code Number at any given time.
RESETTING THE UNIT
Press the RESET button on the rear of the unit to reset the system and clear all
recordings.
MPH2430.O/M.QXD 1/29/03 9:12 AM Page 44