Filter
Top Products
43
REMOTE OPERATION
REMOTE ACCESS CODE
This unit can be operated remotely from almost any touch-tone phone. The Access
Code is preset as shown below:
If the RESET button is pressed, the Access Codes will return to their default settings.
Press a Mailbox button; the correspond-
ing mailbox indicator will blink.
Skip this step if you would like to
change the Access Code for the primary
mailbox.
1
Press and hold the CODE button; the
unit will announce, “Your password is
xxx, please enter new password”.
Release the CODE button.
2
Press and release the DAY button; the
corresponding number will be displayed
and announced. Press and release the
DAY button repeatedly until the desired
first digit of the Access Code is
displayed and mentioned.
3
Repeatedly press the HOUR button ❶
to set the second digit and the MIN
button ❷ to set the third digit. Press
the CODE button ❸ again; the new
Access Code will be announced.
2
3
1
4
CHANGING THE ACCESS CODE
All digits of the Access Code are a combination of numbers 5, 6, 7, 8, 9, 0. Digits 1, 2, 3
and 4 cannot be used when changing the Access Code. You can operate the unit
remotely with the default codes, but we suggest you set your own new code. To
change this code, follow the instructions below:
PRIMARY: 999
MAILBOX 1: 555
MAILBOX 2: 666
MAILBOX 3: 777
MAILBOX 4: 888
NOTE: If your new Access Code is the same as another mailbox, the system will
not record your new code and announce, “Please try again.”
MPH2430.O/M.QXD 1/29/03 9:12 AM Page 43