Filter
Top Products
8
OPERATION (CONTINUED)
Press the FUNC button three times;
“P” will appear and “H” or “L” will
blink.
1
Within eight seconds, press the
CHANNEL/VOLUME Up ❶ or Down
❷ button to select H” (High) or “L”
(Low). Press the PTT button ❸ or wait
eight seconds to confirm and exit.
1
2
3
2
SETTING THE TRANSMIT POWER
Set the transmit power to Hi (1.8W TX power) or Low (500mW TX power) as follows:
Press the FUNC button four times;
“DW” will appear and “d” and “oF” or
a number will blink.
1
Within eight seconds, press the
CHANNEL/VOLUME Up ❶ or Down
❷ button to select the desired
channel. (Select “d” and “oF” for
cancelling or turning off the Dual
Watch function.) Press the PTT
button ❸ or wait eight seconds to
confirm and exit.
1
2
3
2
SETTING THE DW (DUAL WATCH)
This feature allows you to monitor two channels at the same time. While in the Dual
Watch mode, the unit will continuously monitor both the primary and dual watch
channel. Received signals will be heard for five seconds, then the unit will resume
scanning the two channels. Pressing the PTT button during a received transmission
will set the unit to transmit on the same channel. Pressing the PTT button when no
signal is received will set the unit to transmit on the primary channel. Set as follows:
NOTE: If the battery is low, the TX power will be automatically switched to LO.
On FRS frequencies (8-14CH), the power goes to 0.5W automatically. FCC requires
that the transmitting power for FRS channel (8-14CH) must be less than 0.5W
TO CANCEL THE DUAL WATCH
To cancel, simply press the SCAN or FUNC button.
MK1996.OM.QXD 5/19/03 12:03 PM Page 8