Filter
Top Products
10
OPERATION (CONTINUED)
Press the FUNC button seven times;
“C” will appear and the call tone
number will blink.
1
Within eight seconds, press the
CHANNEL/VOLUME Up ❶ or Down
❷ button to set the call tone (1 to 3);
the selected call tone will sound.
Press the PTT button ❸ or wait eight
seconds to confirm and exit.
1
2
3
2
SETTING THE CALL TONES
This unit will provide three user selectable call ringer signals to alert you of an
incoming signal. Set the call tone as follows:
To start Scan mode, press and
release the SCAN button; “SCAN”
will appear in the display and the unit
will scan through the 22 main
channels. When an active channel is
found, it will be heard for five
seconds, and then scanning will
resume.
1
To exit the Scan mode, press the
SCAN ❶ or FUNC ❷ button; “SCAN”
will disappear from the display.
1
2
2
SCANNING CHANNELS
This feature will allow you to monitor all channels automatically for valid signals.
While scanning, you can transmit and receive. When a signal is received, scan is
interrupted and you will hear the channel for five seconds. After five seconds, the unit
will resume scanning unless the SCAN button is pressed again as follows:
MK1996.OM.QXD 5/19/03 12:03 PM Page 10