Filter
Top Products
5
INSTALLATION (CONTINUED)
INSTALLING STANDARD BATTERIES
When battery power is full, will not be displayed. When battery power is low, will
appear in the display. When battery power is almost empty, will blink in the display.
When the Battery Status indicator is empty, it is time to replace your batteries as follows:
INSTALLING AND CHARGING THE RECHARGEABLE BATTERY PACK
When the Battery Status indicator is empty, it is time to replace your batteries or
recharge the battery pack.
IMPORTANT: Do not attempt to charge AAA Alkaline batteries, only use the 4 AAA Ni-
MH rechargeable battery pack (included) and the adaptor (included).
Slide the battery compartment out,
and then lift off to remove.
1
Insert four (4) "AAA" size batteries
(not included) following the polarity
diagram. Put the battery compart-
ment cover back into place.
2
Slide the battery compartment out,
and then lift off to remove as
described in figure 1 above. Insert
the battery pack (included) following
the polarity diagram. Put the battery
compartment cover back into place.
1
To charge, insert the adaptorís plug
into the SPK/MIC/CHG jack while
the unit is off; the LED on the
adapter will light.
2
MK1996.OM.QXD 5/19/03 12:03 PM Page 5