Filter
Top Products
■
Install Modular Connecting Blocks
Install a modular connecting block at each telephone location
Find the modular connecting block from the Cable Extension
Kit and the cable installation tool from the Wiring Installation Kit.
Choose the location for the connecting block according
to the figure. Cut the cable, making sure you allow at
least 4 inches extra.
4 inches
Modular connecting block
TELEPHONE
12 inches
LOCATION
Cable
Cable clip
Baseboard
Floor
Fasten the cable to the connecting block as shown in steps A-K, below.
Loosen screw. Remove cover and set aside.
Use cable stripping part of cable installation
tool to remove 2 inches of cable cover.
2 inches
Mount connecting block
with screws or adhesive
backing provided.
Thread cable through
center of connecting
block until 1/4 inch
of cable cover shows.
Mounting
holes
Align cable
in one of
the notches.
Adhesive
backing
Remove and save
plastic caps
Cut off loose wire ends near
plastic caps. Make sure no wires
touch each other.
Insert wires in this order left
to right:
1 white-blue
2 blue
3 white-orange
4 orange
5 white-green
6 green
7 white-brown
8 brown
Attach appropriate wiring run
label to connecting block.
Align caps and press them down
firmly until they snap in place.
Replace cover and tighten
screw.
10
Customer Installation Instructions