Filter
Top Products
GDK-20W DIGITAL WIRELESS KEY TELEPHONE SYSTEM
84
SECTION 6. ADMIN PROGRAMMING
6.1 GENERAL DESCRIPTION
6.1.1 INTRODUCTION
The GDK-20W Key Telephone System can be programmed to meet each customer's individual need. All programming is
done at station 100(DKT 1) using KD-24D, KD-36D, LKD-30D digital key telephone.
Upon entering the program mode, the key telephone at station 100 cannot operate as a normal telephone but as a
programming instrument with all of the buttons redefined. The keys of the dial pad are used to enter the various data
fields and to enter numerical information. The 24 buttons located at the top of the phone (Flex Buttons) are used to
indicate the specific data field and to enter information. Sometimes
[SPEED]
button is used to delete the data.
See
TABLE 6.2.2.1 - 6.2.2.10
for default data. If this pre-programming suits the customer, additional Admin program is
not necessary. To change admin data, the user enter the admin. programming mode and select program code. During
Admin programming, other keysets in the system operate normally.
When Admin programming, LCD and LED’s indicate current programmed data and status. If the programmer enters
correct data, then LCD and LED’s show the entered data and the data is stored in the temporary buffer area. Real
system databases is not changed and has no effect on telephone operation unless permanent updating procedure is
executed. Pressing
[HOLD/SAVE]
button, all data in the temporary buffer (same as LCD and LED’s show their status)
is saved into permanent memory. Tones are provided to let the programmer know whether data entry is correct
(confirmation tone) or not (error tone).
6.1.2 TO ENTER THE PROGRAMMING MODE
1. Lift handset or press the
[MON]
button on the admin station, and hear ICM dial tone (optional),
2. Press
[TRANS/PGM]
button and dials
*#
(confirmation tone heard),
3. Enter Admin. Password if the password has been set. This procedure places the station into the Admin.
programming mode (confirmation tone heard). And LCD will displays the first step of Admin. programming.(below
LCD)
ADMIN PROGRAM START
PRESS FLEX KEY(1-12)