Filter
Top Products
13
Registering the Konftel 300Wx with a DECT base station
Select > SETTINGS > DECT > REGISTER to start the registration guide in the
Konftel 300Wx.
Please note that you must confirm all your choices by pressing OK.
Select base (1–4).
Four base stations can be registered in the Konftel 300Wx. If no base station has
been programmed, choose no. 1. Numbers being used are indicated by a filled box.
Enter the base station’s security code (PIN code).
The code is 0000 for the Konftel DECT base station. Check with your company’s
switchboard administrator if a different DECT system is being used.
The Konftel 300Wx is now in registration mode and is searching for a base station in registration
mode. Wait until you receive confirmation that registration has been completed. (The base station
has to be in registration mode.)
Registration can be interrupted by pressing . If registration was successful, the
word SUCCESS will appear in the display.
The Konftel 300Wx is now ready to use.
Please see page 23 for other menu options and settings.
If registration was not successful
If registration was not successful, the word FAILURE will appear in the display. Possible
reasons for this:
• Incorrect security code (check with your company’s switchboard administrator).
• A PARK code might be needed (check with your company’s switchboard administra-
tor). Activate PARK ( > SETTINGS > DECT > PARK) and try to register again using
your PARK code.
• No base station within range or not activated in registration mode.
CONNECT TO A DECT SYSTEM