Filter
Top Products
!
To operate properly, your modem must go off-hook and dial - even though you manually dialed the remote
modem's telephone number. Your modem does not have to dial the entire telephone number; one digit is
sufficient to complete the dialing process.
5.
Perform the data transfer. When you finish, return the handset to the cradle.
To hang up, use your communication software's call-termination feature, or type
ATH0
and press Enter from direct connect
mode.
!
The telephone handset is electronically disconnected when the modem goes off-hook. You must hang up your modem to
restore use of your telephone handset.
______________________________
Dialing fax calls manually________
If the digital telephone connected to your KONEXX Office Konnector does not support autodialing, use the following procedure
to dial fax calls manually.
! If your fax software supports a manual fax feature, you can use that procedure instead of the following to dial fax calls
manually.
1.
Prepare your fax/modem or fax machine for sending.
2.
Lift the telephone handset and listen for a dial tone. Leave the handset out of the cradle. DO NOT hang it up, or you will
terminate the call.
3.
Press the Enter key on your computer keyboard if you are using a fax/modem.
OR
Press the
Start
button on your fax machine.
4.
Use the telephone keypad to dial the remote fax telephone number.
5.
When you finish, return the handset to the cradle.
6.
To hang up a fax/modem, use your software's call-termination feature, or type AT H0 and press Enter from direct connect
mode.
OR
To hang up a fax machine, press its
Stop
button.
! The telephone handset is electronically disconnected when the fax/modem goes off-hook. You must hang up your
fax/modem to restore use of your telephone handset.
! Some fax software takes a few moments to prepare a document before dialing. This delay may cause a dial tone "time out"
on many telephones.
To avoid the dial tone time out, either convert the document to fax format before you prepare to send it, or do not lift the
handset from the telephone cradle until the software indicates that it is
ready to dial.
Chapter 5
Receiving data and
faxes
C
hapter 5 describes the procedure for receiving data and faxes.