Filter
Top Products
57
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
LOCK
■ Transceiver Lock
Transceiver Lock is suitable for a typical mobile
installation where you alter most functions with your
microphone. This Lock disables all functions
excluding the following:
• (POWER) switch •
[F]
•
[F]
, [MHz] • SQL controls
• VOL controls • Microphone keys
Press
[F]
, [MHz] to switch Transceiver Lock ON
(or OFF).
•A key icon appears when the function is ON.
■ All Lock
All Lock is ideal when you have no plans to transmit
but you want to monitor a specific channel. This Lock
disables all functions excluding the following two:
• (POWER) switch • [MHz]+[ ]
1 Switch Transceiver Lock ON.
2 Switch OFF the power to the transceiver.
3 Press [MHz]+[ ] to switch All Lock ON (or OFF).
• The key icon slowly blinks when the function is ON.
POWER-ON MESSAGE
Each time you switch the transceiver ON, the factory-
default message appears and stays for approximately
2 seconds. You can program your favorite message in
place of “KENWOOD”.
1 Press [MNU] to enter Menu mode.
2 Select Menu No. 1 (P-ON).
3 Press
[OK]
.
• The current message appears and the last digit blinks.
4 Press [VFO] to clear all digits and move back to the
first digit.
5 Turn the Tuning control, or press Mic [UP]/ [DWN], to
select the first digit.
•To enter a dot after the digit, press [MR]. Pressing [MR]
again clears the dot.
6 Press
[
ss
ss
s
]
.
• The second digit blinks.
7 Repeat steps 5 and 6 to enter up to 7 digits.
• After entering the 7th digit, you need not press
[
ss
ss
s
]
.
•To re-enter the preceding digit, press
[
tt
tt
t
]
.
8 Press
[OK]
again to complete the setting and exit
Menu mode.