Filter
Top Products
30
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
•You can select “0” to “9”, “A” to “Z”, “–”, “/
”, or a space.
•To enter a dot after the digit, press [MR]. Pressing [MR]
again clears the dot.
6 Press
[
ss
ss
s
]
.
• The second digit blinks.
7 Repeat steps 5 and 6 to enter up to 7 digits.
• After selecting the 7th digit, you need not press
[
ss
ss
s
]
.
•To re-enter the preceding digit, press
[
tt
tt
t
]
.
•To clear all digits and move back to the first digit, press
[VFO].
8 Press
[OK]
to complete the setting and exit Menu
mode.
Note:
◆
You can assign names only to memory channels in which you have
stored frequencies and related data.
◆
The stored names can be overwritten by repeating steps 1 to 8.
◆
The stored names also are erased by clearing memory channels.
SWITCHING MEMORY NAME/ FREQUENCY DISPLAY
After storing memory names, you can switch the display
between memory names and frequencies. You may
sometimes want to confirm frequencies stored in named
memory channels.
1 Press [MR] to enter Memory Recall mode.
2 Press [MHz] to switch between memory name and
frequency display.
NAMING MEMORY CHANNELS
You can name memory channels using up to
7 alphanumeric characters. When you recall a named
memory channel, its name appears on the display
instead of the stored frequency. Names can be
callsigns, repeater names, cities, names of people, etc.
Note:
You can also name the Priority channel, but you cannot name the
Call, L1 to L6, nor U1 to U6 channels.
1 Recall the desired memory channel.
2 Press [MNU] to enter Menu mode.
3 Select Menu No. 5 (MEM.NAME).
4 Press
[OK]
.
• The first digit blinks.
• If you recall a memory channel that has a name stored,
the last digit blinks.
5 Turn the Tuning control, or press Mic [UP]/ [DWN], to
select the first digit.