Filter
Top Products
8 EchoLink
TM-D710A/E CONTENTS 63
Figure 8-41 Sysop Setup Window: Options Tab
The initial settings are fine to use. No changes are necessary. Finally, click the RF Info tab.
Figure 8-42 Sysop Setup Window: RF Info Tab
At this point, you must enter your link station information. While initially experimenting and setting
up your station, it’s best not to enter this information. This information is sent to the EchoLink
server. After you disconnect from the EchoLink server, this information will continue to be public
via the server for some time. Heed this warning!
This is the information that you can enter:
Lat: Enter latitude.
Lon: Enter longitude.
Freq: Enter operational frequency.
PL (if any): Enter Tone frequency for access (e.g. the CTCSS frequency configured in
a TM-D710A/E).
Power (W): Select from the dropdown list the power closest to your transmit power.
HAAT (ft): Select from the dropdown list the height closest to your antenna height.
Antenna Gain (dB): Select from the dropdown list the gain closest to your antenna gain.
Directivity: Select from the dropdown list the direction of maximum antenna gain. For an
omnidirectional antenna, select “Omni”.
Report Status via APRS: Do not check.