Filter
Top Products
38
BaTTery saver
This transceiver has been designed to give you the most out of
your battery power. The battery saver function decreases the
amount of power used when a signal is not being received and
no operations are being performed.
While using the transceiver, battery saver will automatically
switch ON after 5 seconds have elapsed with no operations or
received calls. Operating the transceiver or receiving a call will
switch this feature OFF until 5 seconds of non-operation occurs
again.
To turn this function on or off:
1 With the transceiver power OFF, press and hold the MENU
key while turning the transceiver power ON (for 1 second).
2 Press the or key to select “ ”.
3 Press the MENU key then press or to select “ ”
(battery saver on) or “
” (battery saver off).
4 Press the MENU key to exit the selection.
5 Press the PTT, MON, or CAL key to exit Setting Mode.
Note: While the Battery Saver is operating, the LED may ash
green when receiving a QT/DQT signal which does not match
the QT/DQT tone/code set up in your transceiver.