Kenwood TK-3230 Two-Way Radio User Manual


  Open as PDF
of 61
 
17
SCanninG the ChannelS
You can scan the transceiver channels to search for a signal.
Whenthetransceiververiesasignalonachannel,itproceeds
tocheckwhetherornotitsQT/DQTsettingmatchesthat
which is set up on your transceiver (if you have set a channel
withQT/DQT).IftheQT/DQTmatches,thetransceiverstops
at the channel and opens the squelch so you can listen to the
call.IftheQT/DQTdoesnotmatch,thecallisignoredand
scanning continues.
Before you can use the scan function, ensure that it is
activated. You can turn the scan function (the ability to perform
scan) ON or OFF in Setting mode.
1 With the transceiver power OFF, press and hold the MENU
key while turning the transceiver power ON (for 1 second).
2 Press the or key to select “ ”.
3 Press the MENU key then press or to select “ ”
(scan function disabled) or “
”(scanfunctionenabled).
• If you select “ ”,youwillnolongerbeabletoperform
scan by pressing and holding the key {page 18}.
4 Press the MENU key to exit the selection.
5 Press the PTT, MON, or CAL key to exit Setting Mode.
 previous next