Filter
Top Products
Caller ID Speaker Phone V10M10_IM_EN_03232007
www.jWIN.com
- 8 -
GETTING STARTED
Getting the Telephone Ready for Use- continued
4. Plug one end of the flat telephone cord into the jack in the rear of the unit’s base
(marked TEL-LINE), and the other end into the wall jack which supplies
telephone service.
Mounting the Phone on the Wall
1. Choose a desired wall location for the phone.
2. Align nails or picture hooks with the wall-
mount hanger located on the bottom
surface of the base.
3. Hammer nails or hangers into the wall so
the phone can hang flush with the wall.
4. Set the removable receiver tab with lip
toward the top of the base.
5. Hang phone on nails or picture hangers making certain that the phone is flush
with the wall.
Connecting the Stand for Flat Surface Placement
When using the JT-P531 on a flat surface, it is recommended that you use the
included stand.
1. Remove the stand from the plastic wrapper.
2. Turn the phone upside down with the battery compartment closest to you.
3. The stand attaches above where the battery compartment is located.
Wall mount
han
g
e
r