Filter
Top Products
Caller ID Speaker Phone V10M10_IM_EN_03232007
www.jWIN.com
- 10 -
GETTING STARTED
Installing the Batteries
The JT-P531 requires three (3) AAA batteries, which are used to operate the
speakerphone, the LCD display, and to retain Caller ID data and any settings
programmed into the phone. Using an optional AC adapter (see Notes below) will
increase the battery’s life span, requiring less frequent battery replacement.
1. Remove the battery compartment cover at the
bottom of the unit.
2. Carefully install three (3) AAA batteries by
observing the polarity direction shown in the
battery compartment.
3. Replace the cover.
Notes:
• Whether installing batteries for the first time or replacing them, do not mix old
and new batteries, nor should alkaline, standard (zinc-carbon), or rechargeable
(nickel-cadmium) batteries be used together.
• When not using the phone for a long period of time, remove the batteries to
prevent possible leakage and corrosion. Keeping the phone powered by the
optional AC adapter, discussed below, will preserve all data and settings in the
phone’s memory.
Using an AC Adapter (Optional)
If an optional AC power adapter (not included) is used, it plugs into the DC 9V jack
on the rear of the unit and converts common household AC electricity into low
voltage DC power, suitable for the phone’s operation. Such adapters are commonly
available, but before buying, be sure that it can provide the necessary +/- polarity, as
indicated on the unit’s rear panel, just below the DC 9V jack. Once connected, plug
the adapter’s other end into an un-switched (always on) AC outlet, outlet strip, or
extension cord. Even when an AC adapter is employed, the use of batteries is
recommended as a backup in case AC power is ever lost.