Jwin JT-P551 Conference Phone User Manual


 
Caller ID Speaker Phone w/SOS Remote Control V11M11_IM_EN_04222008
www.jWIN.com
- 18 -
OPERATIONAL INSTRUCTIONS
Receiving a call Using the Pendant Remote
Telephone will ring to alert the user of an incoming call.
1. When there is an incoming call, pick up the handset or press [SPEAKER]
to receive the call.
2. You may also use pendant remote to pick up the call. When there is an
incoming call, just press the button of the pendant remote and the
telephone will be put in speakerphone operation.
3. After finishing the conversation, press and hold the button of the pendant
remote again for a few seconds to terminate the call and the telephone will
be returned to on-hook state.
Reviewing the Caller ID List
Press [] or [] to review incoming calls (up to 60 calls).
Erasing Data from the Caller ID List
1. Press [] or [] to find the number you wish to erase.
2. Press [DEL] to erase the number from the list.
3. Press [DEL] for approximately 3 seconds for the LCD to show “ERASE
ALL?”
4. Press [DEL] again to erase the entire caller ID list.
Calling a Number from the Caller ID List
In on-hook state:
1. Press [] or [] to select the desired caller ID record.
2. If the record is less than 10 digits, press [OK/DIAL] once, pick up the
handset and the displaying number will be dialed out automatically.
3. If the record is 10 digits and the first 3 digits of the record is the same as set
area code, press [OK/DIAL], the three digits area code will be erased and it
will display 7 digits number only. The LCD will display “PICK UP OR ADJ”.
Press [OK/DIAL] again to return back to 10 digits with adding area code.
Press [OK/DIAL] once again to show 11 digits with adding ‘1’ as the first
digits and area code as well. Pick up the phone and the number will be
dialed out automatically.