Inter-Tel 827.8662 Telephone User Manual


 
ADDENDUM TO ISSUE 4 OF THE AXXESS MANUAL OCTOBER 1997
Page 7 of 73
Call Routing to Public Network
This feature changes the AXXESS system in the fol-
lowing ways:
Call Routing Tables can be programmed to route
outside calls to outgoing trunks, using Automatic
Route Selection (ARS) or a trunk group. However,
Primary Rate trunks can be used only through
ARS; individual B-channel trunks or trunk groups
containing B-channel trunks will not function
properly with this feature.
The system provides a means for the trunk-to-trunk
call to be supervised including normal trunk dis-
connect supervision and timer disconnect supervi-
sion.
Toll restriction will be enforced on call attempts
made from one trunk to another trunk or trunk
group (but not on trunk-to-ARS calls).
Access To Outgoing Trunks
Call Routing Tables now allow patterns that route calls
to destinations of individual trunks, trunk groups, and
ARS anywhere single ring-in destinations are pro-
grammed.
If the caller is routed to a trunk or trunk group that is
busy, the system will camp on to the trunk. The caller
will hear busy tones, followed by music. When a trunk
becomes available, the caller hears dial tone and can
complete the call.
Toll Restriction
To provide security on outgoing calls made through di-
rect trunk-to-trunk interfaces, the toll restriction of the
selected outgoing trunk will be checked. However, if
ARS is used, toll restriction is not checked.
The toll restriction of the incoming trunk’s group and
that trunk’s “Subject To Toll Restriction” flag are not
checked.
If a caller dials a number that is not allowed through toll
restriction, the call will be routed to the primary atten-
dant.
Programming Call Routing Tables
Call Routing to the Public Network is programmed
through the Call Routing Table screens for program-
ming Individual Patterns, Area Code Batch Inserts, or
Batch Ring-In Destinations, as shown on the next page.
Even though Primary Rate trunks appear in the selec-
tion lists, they can only be used by selecting ARS; indi-
vidual B-channel trunks or trunk groups containing B-
channel trunks will not function properly with this
feature.
NOTE: This cannot be programmed if you enter data-
base programming using the “User” password and it
cannot be programmed through an Administrator’s
keyset.
NOW YOU CAN CHOOSE ARS,
TRUNKS, OR TRUNK GROUPS