Filter
Top Products
BROADSOFT PARTNER CONFIGURATION GUIDE – GRANDSTREAM HT286/386/486/488/496/BT100 DOCUMENT NUMBER
©
2007 GRANDSTREAM. PROPRIETARY AND CONFIDENTIAL; DO NOT DUPLICATE, OR DISTRIBUTE. PAGE 13 OF 23
6 Configuration
Grandstream HT-286 / HT-386 / HT-486 / HT-488 / HT-496 / BT-100 can be configured
via Web GUI Interface as well as via Configuration File through TFTP or HTTP.
The HT-286 / HT-386 / HT-486 / HT-488 / HT-496 / BT-100 accepts configuration files in a
proprietary binary format which is produced by the Grandstream configuration tool. The
configuration tool creates a device configuration file based on a configuration template and
the device’s MAC address. All Grandstream products’ sample configuration templates are
available on Grandstream’s web site. A configuration template file contains all
configuration parameters available for a product, with comments describing allowed
values of the parameters. For a detailed parameter list, please refer to the corresponding
firmware release configuration template
[2].
When Grandstream device boots up or reboots, it will issue request for a binary
configuration file named “cfgxxxxxxxxxxxx”, where “xxxxxxxxxxxx” is the MAC address of
the device, i.e., “cfg000b820102ab”. The configuration file name should be in lower cases.
Grandstream offers free Configuration File generator software in both Linux/Unix and
Windows platform. Both Configuration File Generators can be downloaded from
Grandstream official web site at
http://www.grandstream.com/configurationtool.html [2].
The HT-286 / HT-386 / HT-486 / HT-488 / HT-496 / BT-100 can be configured with a
configuration file using the Trivial File Transfer Protocol (TFTP) or through its embedded
web server. The following examples describe how to set the parameters using a
configuration file. This configuration description assumes the HT-286 / HT-386 / HT-486 /
HT-488 / HT-496 / BT-100 will use the Dynamic Host Configuration Protocol (DHCP) to
obtain an IP address and other network settings. The HT-286 / HT-386 / HT-486 / HT-488
/ HT-496 / BT-100 should be configured to load the configuration file each time it resets or
re-synchronizes. For detailed information on automated provisioning, please check the
HT-286 / HT-386 / HT-486 / HT-488 / HT-496 / BT-100 User Manual Error! Reference
source not found..
The capabilities of the HT-286 / HT-386 / HT-486 / HT-488 / HT-496 / BT-100 have been
verified for use with BroadWorks based on the settings described in the following table.
For more information on the meaning, purpose, and applicability of the individual
configuration items, see the HT-286 / HT-386 / HT-486 / HT-488 / HT-496 / BT-100
configuration template
[2] .
Configuration Files
Files Provided by Partner Level Description
HT-286 / HT-386 / HT-486 / HT-488 / HT-
496 / BT-100 Configuration Template
Example: sipp1_config_1.1.0.8.txt
sipp2_config_1.0.3.96.txt
System and
Subscriber
Contains configurable parameters that
apply to an individual device in a
deployment.
cfgMAC
Example: cfg000b82000000
System and
Subscriber
Binary configuration file generated
from configuration template and an
individual device’s MAC address.