Filter
Top Products
FIRMWARE VERSION 1.0.4.23 GXP2120/GXP2110/GXP2100/GXP1450 USER MANUAL Page 59 of 69
Call-Waiting Tone
Busy Tone
Reorder Tone
Syntax: f1=val,f2=val[,c=on1/off1[-on2/off2[-on3/off3]]];
(Frequencies are in Hz and cadence on and off are in 10ms)
ON is the period of ringing (“On time” in ‘ms’) while OFF is the period of
silence. In order to set a continuous ring, OFF should be zero. Otherwise
it will ring ON ms and a pause of OFF ms and then repeat the pattern.
Up to three cadences are supported.
Intercom User ID
Configures the intercom extension number for account 1 to dial out (Not
applicable to GXP1450). This User ID is mapped to the INTERCOM
button on the phone.
Disable Call-Waiting Disables the call waiting feature. The default setting is "No".
Disable Call-Waiting Tone
Disables the call waiting tone when call waiting is on. The default setting
is "No".
Disable Direct IP Calls Disables Direct IP Call. The default setting is "No".
Use Quick IP-Call mode
When set to "Yes", users can dial an IP address under the same
LAN/VPN segment by entering the last octet in the IP address. To dial
quick IP call, off hook the phone and dial #XXX (X is 0-
9 and XXX
<=255), phone will
make direct IP call to aaa.bbb.ccc.XXX where
aaa.bbb.ccc comes from the local IP address REGARDLESS of subnet
mask. #XX or #X are also valid so leading 0 is not required (but OK). No
SIP server is required to make quick IP call. The default setting is "No".
Disable Conference Disables the Conference function. The default setting is "No".
Enable MPK sending DTMF
Enables Multi Purpose Key to send DTMF during the call (Not applicable
to GXP1450). The default setting is "No".
Disable DND Button
If set to "Yes", the DND button will not set the phone to DND. The default
setting is "No".
Disable Transfer Disables the Transfer function. The default setting is "No".
Auto-Attended Transfer
If set to "Yes", the phone will use attended transfer by default. The
default setting is "No".
In-call dial number on pressing
transfer key
Configures the number for the phone to dial as DTMF during the call
using TRAN button.
Configuration via Keypad Menu
Configures the access control for the users to configure from keypad
Menu. There are three different options:
• Unrestricted. All the options can be accessed in keypad Menu.
• Basic settings only. The CONFIG option will not display for users
to access in keypad Menu.
• Constraint Mode
. CONFIG, FACTORY FUNCTIONS and