Filter
Top Products
39
You experience static, noise, or fading in and out
• The handset may be out of range of the base. Move closer to the
base.
• Make sure base is not plugged into an outlet with another household
appliance. If necessary, relocate the base.
• Charge the battery.
Unit beeps
• Clean charging contacts on cordless handset.
• See solutions for “No dial tone”.
• Replace the battery.
Memory Dialing doesn’t work
• Did you program the memory location keys correctly?
• Did you follow proper dialing sequence?
Unit locks up and there is no communication between the base and
cordless handset
• Unplug the AC power adaptor from the wall outlet and the back of
the base. Remove the handset battery. Wait for 30 seconds and plug
the power adaptor back into the base and wall outlet. Reconnect the
battery and charge for 16 hours.
Handset displays "SEARCHING" or "OUT OF RANGE" and cannot link up
with the base when the TALK/CALL BACK button is pressed.
• Handset may be out of range of the base. Move closer to the base.
• Make sure the power adaptor is properly installed.
• Disconnect the handset battery and plug it in again. Place the
handset on the cradle for at least to 3 minutes.
• Disconnect the power adaptor and plug it in again. Then place the
handset on the cradle for at least to 3 minutes.
Handset displays "HANDSET NEEDS REGISTRATION"
• Follow the programming in the telephone procedures to re-register
the handset to the base.
• Press the SELECT button to begin handset registration. Follow
instructions on handset screen.
Caller ID Solutions
No Display
• Charge the battery (for 16 hours). Or replace the battery.
• Make sure that the unit is connected to a non-switched electrical
outlet. Disconnect the AC power adaptor from the base and
reconnect it.