Filter
Top Products
1
Do Not Disturb (DND)
This feature allows you to turn off all the handset ringer(s) at once,by
pressing one button at the base unit, even though the ringer volume of
handset(s) has been set to HIGH or LOW.
1. In the standby mode, press the DO NOT DISTURB button on the base.
. The DND indicator will light and DO NOT DISTURB shows in each
handset display.
3. To cancel, press the DO NOT DISTURB button again.
NOTE: You can press the DO NOT DISTURB button and
activate the function immediately, even when there is
incoming call ringing in, or during call screening after the
call is taken by the answerer.
Room Monitor
(This is only applicable when or more handsets are registered to the
same base unit.
IMPORTANT NOTE: The following procedures can ONLY be
done with Model 28011 and 28041 handsets.
1. Make sure your handset and the handset to be monitored are not in
talk mode.
. Press the MENU button and use the 6 or 5 button to scroll to ROOM
MONITOR.
3. Press the SELECT button and all the registered handset numbers and
handset names show on the display.
4. Use the 6 or 5 button to select the desired handset. Press the SELECT
button to conrm.
If handset 1 is the room monitoring initiator, the following displays will be
shown during the room monitor:
HANDSET 1
ROOM MONITOR
HANDSET 2
HANDSET 2
FROM
HANDSET 1
ROOM MONITOR
Originating Handset Receiving Handset
NOTE:
1) If handsets have been named, then the name will be
displayed on the LCD instead of handset numbers.
2) During the room monitoring, it will emit a beep tone if
there are incoming calls. You may press the TALK/CALL
BACK button or SPEAKER button to answer the call and quit
the room monitor mode.