Filter
Top Products
11 By Firstech, LLC By Firstech, LLC 10
Quick Reference
STEP 1: Enter remote programming mode by holding down buttons (II + III) for 2.5 seconds. The remote will beep once and the LCD will read
“Prog” to indicate that you have successfully entered programming mode.
STEP 2: After entering programming mode. Adjust the time settings by tapping button (I) to change the hour and tapping button
(II) to adjust the minutes.
STEP 3: Once the desired time has been set, exit remote programming by holding down buttons (II + III) for 2.5 seconds. The remote will beep
three times indicating that you have successfully exited programming mode.
p@@c@Hlcd@r@oI
Quick Reference
Rw@r@b@f
Button Duration Additional Programming Function / Description
Required
0.5 seconds no Locks doors and/or arms alarm. Tap again to unlock door and/or disarm alarm.
2.5 seconds Option 2-11 Run time extender. Resets remote start and turbo run time while vehicle is remote started
0.5 seconds no Aux 1. Triggers the auxiliary 1 output (most commonly used for rear defrost or window roll-down)
2.5 seconds no Activates the remote start. Repeat and remote start will shut off
0.5 seconds no Aux 2. Triggers the auxiliary 2 output (most commonly used for rear defrost or window roll-down)
2.5 seconds no Trunk pop. Triggers the trunk release output and opens the vehicle’s trunk.
0.5 seconds no Car Check (updates vehicle status on remote pager) / Secure Auxiliary / Temperature Display / Vehicle Voltage Display
2.5 seconds no Panic/vehicle locator (flashes vehicle’s parking lights and sounds siren and horn)
0.5 seconds no Turns siren chirps on/off (Note: With the siren chirps off, it will still sound in the event the alarm is triggered)
2.5 seconds no Option programming menu 1. For use during installation.
0.5 seconds no Valet mode (see page 5 for details)
2.5 seconds no Turns the shock sensor on/off. (Alarm or Alarm/Starter systems only)
0.5 seconds Option 1-9 Drive lock. Activates ignition controlled door locks.
2.5 seconds no Option programming menu 2. For use during installation.
I
I + II
I + III
I + IV
II
III
IV