Filter
Top Products
33 By Firstech, LLC By Firstech, LLC 32
Advanced System Functions
s@v@s
The optional Secure Valet Switch prevents the alarm from being put into valet mode through cycling the ignition on/off five times. The Secure Valet
Switch is more secure than traditional toggle / valet switches because it requires a two digit code. IMPORTANT: The first two digits of the RPS
unlock/disarm pass code will be the default pass code for the secure valet - you do not need to program them independently. If you are not using the
RPS unlock, following the below procedures to program your secure valet pass code;
STEP 1: Turn on Option 3-10-III. (Dealer programmed option)
STEP 2: Turn ignition key to the on position.
STEP 3: Hold down the valet switch for 1.5 seconds. The LED on the valet switch will begin to flash rapidly with successful completion of this step.
STEP 4: Enter the first digit of the desired two digit pass code by depressing the switch the number of times that coordinates with the desired first
number. For example, to enter 3, depress the switch 3 times, then wait.
STEP 5: The LED will confirm the first number by flashing BLUE slowly. Once the LED begins to flash rapidly, enter your second number by
repeating step 4.
STEP 6: Turn the ignition off - the Secure Valet Switch is now programmed. Follow steps 3 - 5 to enter your Secure Valet code.
Advanced System Functions
t@s@m
Timer start mode is used to cool or warm the vehicle without manually starting with the key or from the CompuStar remote. While
engaged, timer start will activate even while the remote is out of range. Tap buttons (II+IV) simultaneously for 0.5 seconds to activate
timer start mode. The remote will beep once and the timer start icon will illuminate just above the clock icon. Repeat the same step to
turn off timer start mode. Timer start mode will be cancelled any time the vehicle is started manually or remotely. To change from the
default setting to optional settings, see your local CompuStar dealer.
Default1: Will start every 3 hours for a 24 hour cycle, or until the vehicle is remote started or started by key, and run for 4 minutes (8 minutes for diesel).
Option2: Will start every 1.5 hours for a 24 hour cycle, or until the vehicle is remote started or started by key, and run for 4 minutes (8 minutes for diesel).
Option3: Will start at the time specified on the 2 way remote once within 24 hours and run for either 15, 25, 45 or 3 minutes (see your local dealer to
change the run time options).
Option4: Will start at the temperature specified on the Cold/Hot Start Mode below once within 24 hours every day. This option requires a cold or
hot temperature setting as a safety feature. The system will only start if it is below the cold temperature settings or above the hot temperature settings.