Filter
Top Products
27 By Firstech, LLC By Firstech, LLC 26
General System Functions
t@@b@q
When in range of your vehicle, the remote will display the vehicle’s temperature and vehicle battery voltage upon tapping button (IV).
The temperature will be displayed after tapping button (IV) for 0.5 seconds. Tap button (IV) a second time within four seconds to
display the vehicle’s battery voltage. Tap button (IV) a third time within four seconds to display the remote’s battery voltage.
If you tap button (IV) and you do not get any response from the remote, the remote pager is most likely out of range to receive commands. If you tap
button (IV) and the remote reads “FAIL” then your temperature sensor is not installed or may be malfunctioning.
s@a@O@d
Upon lock/arm and unlock/disarm, you can eliminate vehicle s audible confirmation by muting the siren. Normally, the siren will
chirp once to indicate the system is locked/armed and twice to indicate the system is unlocked/disarmed. To mute the siren tap
buttons (I+II) simultaneously for 0.5 seconds. When the siren is muted, the siren icon will no longer be displayed on the LCD.
IMPORTANT: Even when the siren is muted, it will still go off in the event the alarm is triggered.
General System Functions
r@m@O@v@m
All CompuStar 2 Way LCD remotes have the option to be muted. To make the remote silent you must turn on vibration mode;
STEP1 : Enter remote programming mode by holding down buttons (II + III) simultaneously for 2.5 seconds. The remote will beep
once and the LCD will read “Prog” to indicate that you have successfully entered programming mode.
STEP2 : To set vibration mode simply tap button (IV) one time for 0.5 seconds after entering remote programming mode.
STEP3 : Exit remote programming by holding down buttons (II + III) simultaneously for 2.5 seconds. The remote will beep three times indicating
that you have successfully exited programming. The vibration icon will remain illuminated on the LCD indicating the remote is in remote
mute/vibration mode.
s@s@oOo
Hold buttons (I+III) simultaneously for 2.5 seconds to turn on and off the shock sensor. The remote will beep twice and the shock
sensor icon will illuminate to confirm the shock sensor is off. The remote will beep once and the shock sensor icon will disappear to
confirm the shock sensor is on.
IMPORTANT: Turning off the shock sensor also turns off the optional sensor.
Adjusting the shock sensor sensitivity is done at the actual sensor, which is generally mounted somewhere under the vehicle’s dashboard. The higher
the number on the dial means greater sensitivity to impact. The recommended dial setting for most vehicle’s is somewhere between 2 & 4. If you are
testing your sensor, please note that the shock sensor does not recognize impact for 30 seconds after the system has been armed.