Filter
Top Products
31 By Firstech, LLC By Firstech, LLC 30
Advanced System Functions
c@c@O@rps@Hr@p@sI
The RPS is an optional feature. The car call/RPS feature uses a remote paging sensor that is designed to be mounted on the inside of the windshield.
After the RPS has been triggered, the car call icon will illuminate and the remote will ring several times if the remote is in range to receive commands.
To trigger the car call or RPS sensor, you must knock on the windshield in front of the RPS at least two times. The switch on the RPS will adjust paging
sensitivity - the smaller the dot represents the least sensitive setting. Use a key or pen for best results. If you do not want the remote to receive pages
from the RPS, follow the below steps to turn the feature off;
STEP1 : Enter remote programming mode by holding down buttons (II + III) simultaneously for 2.5 seconds. The remote will beep once and the LCD
will read “Prog” to indicate that you have successfully entered programming mode.
STEP2 : Once in programming mode, you can turn the feature off by tapping button (III) for 0.5 seconds. The RPS icon will
disappear. Repeat this step to turn the car call feature back on.
STEP3 : Exit remote programming by holding down buttons (II + III) simultaneously for 2.5 seconds. The remote will beep three times indicating
that you have successfully exited programming. The car call icon will no longer be illuminated on the LCD indicating that the remote is not in car call
mode.
Advanced System Functions
rps@Hr@p@sI@u@O@d
The RPS is an optional feature. Basic RPS and car call functions do not require programming, however in order for the sensor to unlock/disarm the
vehicle you must perform the following procedures;
STEP 1: Disarm/unlock the alarm (remote must be programmed first)
STEP 2: Turn ignition key to the “on” position and the leave the driver’s door open
STEP 3: Knock on the windshield in front of the RPS a total of 10 times (each time you knock the LED on the RPS will flash RED). The LED will begin
to flash rapidly in BLUE with successful completion of this step.
STEP 4: Enter the first digit of the desired four digit pass code by knocking on the windshield in front of the RPS the desired number of times. For
example, to enter 3, knock on the sensor 3 times (each time you knock the LED will flash RED) then wait.
STEP 5: The LED on the RPS will confirm your first number by flashing BLUE slowly. Once the LED begins to flash rapidly in BLUE, enter your
second number by repeating step 4.
STEP 6: Repeat steps 4 & 5 to enter all four numbers.
STEP 7: Turn the ignition OFF - the RPS disarm/unlock feature is now programmed. Follow steps 3 - 5 to enter your disarm/unlock code.