Filter
Top Products
By Firstech, LLC 22 23 By Firstech, LLC
General System FunctionsGeneral System Functions
Tap button (I) for 0.5 seconds to lock/arm and unlock/disarm. If your vehicle is locked, tap button (I) to unlock; if your vehicle is
unlocked, tap button (I) to lock. If equipped this will also activate your starter kill and anti grind feature. You will not be able to start
your vehicle with the key until unlock/disarm.
IMPORTANT : If the alarm has been triggered (Siren is going off), you must wait until the remote pager has been paged before disarming the alarm
- the first button tap will shut off the alarm and the second will unlock/disarm the system.
a@lOa@@uOd
The system can be configured to passively lock and arm the vehicle. Put the system in passive by tapping buttons (II+III)
simultaneously for 0.5 seconds. The remote will beep once and the passive icon will illuminate to indicate the system is in passive
lock and arming mode.
While in passive mode, the system will lock and arm the alarm 30 seconds after the last door is closed. As an indicator that the vehicle is going to
passively lock and arm, the siren will chirp once and the parking lights will flash once at both 10 and 20 seconds prior to passively locking and
arming. If you want the system to passively arm and not passively lock, ask your local CompuStar dealer to turn Option 1-8 to setting II.
p@lOa
Press button (II) for 2.5 seconds to remote start an automatic transmission vehicle. If you are in range and if the vehicle is ready to remote start, the
remote will beep once and the CompuGLO backlight will light up to indicate that the remote start command has been successfully transmitted.
If you are in range and the remote beeps three times, there is a remote start error. Refer to the remote start error diagnostic on the last page of this
manual for details.
Upon receiving confirmation that your vehicle is running, the LCD will flash the exhaust icon and the clock icon will begin to show the
amount of run-time remaining. The remote start run-time can be programmed for 3, 15, 25 or 45 minutes - ask your local CompuStar
dealer to adjust Option 2-7 if you would like a run-time other than 15 minutes (default).
IMPORTANT: Your vehicle s key must be inserted into the ignition and turned to the on position prior to driving your vehicle. If the foot brake
is depressed prior to the key being in the on position, the vehicle will shut off.
In order to remote start a manual transmission vehicle, the system must first be set in Reservation Mode. Reservation Mode must be set each and
every time you want to remote start a manual transmission vehicle. The purpose of Reservation Mode is to leave the transmission in neutral before
exiting the vehicle.
IMPORTANT
The transmission must be left in the neutral position. The vehicles windows must be rolled up.
The vehicles door pins must be in working order. Do not set reservation mode or remote start with people in the vehicle.
Do not install this remote start on a manual transmission vehicle that has a convertible or removable top.
a@t@r@s@f
m@t@r@s@f@Hr@mI