Filter
Top Products
PRI – GSM Multi-Cell Gateway
35
Chapter 10: TCP/IP Setting
TCP/IP settings task list
:
1. Disconnect the COM cable from the Multi-Cell system.
2. Install RJ-45 cable to the Management PC connected to the Multi-Cell network.
3. Execute to the same LAN Network Enabler Administrator program, provided on the installation CD
at the directory LAN Tools;
4. If your IP addresses are between 192.168.0.1 and 192.168.0.255, connect the Multi-Cell to LAN
access point and continue to step 6, if other, then proceed to the next step;
5. Connect the Multi-Cell system to the management PC, with Network Enabler installed
on it, via a NET Cross connect cable, supplied in the package.
Refer to :
Chapter 1: Connecting the Cables
for more details.
6. Set the PCs IP to 192.168.0.XXX, where XXX is the three last digits of the ESN, written on a sticker,
attached to the Multi-Cell, added to 101;
7. Engage the Network Enabler;
8. Click the
[Search]
button to begin the search;
9. The Multi-Cells IP should appear in the next screen:
10. Double click on the IP. Then Press the Network tab. The next screen will open: