Emerson IC172 Two-Way Radio User Manual


 
28
Changing The Lithium Battery
Like all batteries, eventually the built in lithium battery will need to be replaced. A
number of factors, such as, the length of time between the date the radio was
manufactured and the date you plugged it in for the first time determine the amount
of time before replacement. During this initial storage period, the lithium battery is
supplying power to the SmartSet
®
computer memory. Once you plug the radio in,
your household outlet supplies the power, and the battery is not being used. A
fresh lithium battery can supply power to the SmartSet
®
computer for at least 3
years even if it is never connected to an AC power supply. If your clock radio was
connected to your AC supply within a few months after it was manufactured, and
you experience only the normal, nuisance type, short duration power interruptions,
your battery may last for up to 5 years or even longer.
When the battery power drops below a certain level, the LOW indicator will
flash. When you see this indicator, you should change the battery as soon as it is
convenient for you to do so. To change the battery proceed as follows:
1.) Purchase a replacement 3V lithium battery wherever batteries are sold. The
battery type is CR2450 or equivalent.
2.) Remove the battery from its package so it is ready to install.
IMPORTANT: Leave the radio AC power cord connected to your AC outlet.
This will provide power to the SmartSet
®
computer memory while the
original lithium battery is removed.
3.) The battery holder is located on the back panel. See illustration on next page.
Use a small screw driver to remove the screw securing the battery holder to
the cabinet.
BE CAREFUL NOT TO LOSE THIS SMALL SCREW!
iC172 IB 301207new3.p65 26/3/2008, 11:1128