Filter
Top Products
English
www.doro.com 33
The Answering Machine (5065R)
Remote Control
This machine can be remotely accessed using an ordinary tone dialling
telephone. Dial the telephone number to which the answering machine is
connected, after the OGM has been played enter your Four digit remote
code. Once the code is accepted several remote options are available.
1.
Dial the telephone number to which the answering machine is
connected.
2.
Press
*
after the OGM is played.
3.
Enter your four digit remote code (1111 when supplied).
4.
The number of new ICM’s will be announced, and then playback will
begin, (to stop playback press
8
).
5.
Select an option from the list below.
6
.
Once you have nished accessing the machine replace the handset.
Command
Function
1
..................................
Repeat/skip to previous message
2
..................................
Playback of messages
3
..................................
Skip to next message
42
................................
Record a MEMO, (to stop recording press 8)
45
................................
Record new outgoing message, (to stop
recording press 8)
6
..................................
Erase individual messages during playback
7
..................................
Switching On the answering machine
8
..................................
Stop
9
..................................
Switching Off the answering machine
Please note!
If the machine doesn’t respond correctly to the remote control commands, try pressing
the telephone buttons for a longer or shorter time. In normal cases, the answering
machine should react to tones approximately 0.5 – 1 seconds in length, but longer
tones may be necessary on certain telephone networks.
If you do not enter any remote control command, the answering machine will disconnect
after a few seconds.