Filter
Top Products
Operations Guide 930500E CyberData Corporation
40
Installing the VoIP V3 Indoor Intercom
Configure the Sensor Configuration Parameters
2. On the Sensor Configuration page, enter values for the parameters indicated in Ta bl e 2-13.
3. After changing the parameters, click Save Settings.
Table 2-13. Sensor Configuration Parameters
Web Page Item Description
Door Sensor Settings
Door Sensor Normally Closed Select the inactive state of the door sensors.
Door Open Timeout (in seconds) Select the number of seconds that you want to pass before the
door sensor is activated.
Flash Button LED Check this box to flash the LED until the sensor is deactivated
(roughly 10 times/second).
Activate Relay Check this box to activate the relay until the sensor is deactivated.
Play Audio Locally Check this box to loop an audio file out of the Intercom speaker
until the sensor is deactivated.
Make call to extension Check this box to call a preset extension (once).
Play recorded audio Check this box to play a pre-recorded audio file (once).
Dial Out Extension Enter the desired dial-out extension number.
Dial Out ID Type the desired Extension ID (64 character limit).
Use this button to test the door sensor.
Intrusion Sensor Settings
Flash Button LED* Check this box to flash the LED until the sensor is deactivated
(roughly 10 times/second).
Activate Relay Check this box to activate the relay until the sensor is deactivated.
Play Audio Locally Check this box to loop an audio file out of the Intercom speaker
until the sensor is deactivated.
Make call to extension Check this box to call a preset extension (once).
Play recorded audio Check this box to play a pre-recorded audio file (once).
Dial Out Extension Enter the desired dial-out extension number.
Dial Out ID Type the desired Extension ID (64 character limit).
Use this button to test the Intrusion sensor.
Click the Save button to save your configuration settings.
Note: You need to reboot for changes to take effect.
Click on the Reboot button to reboot the system.