ClearOne comm 900 Telephone User Manual


 
Appendix— Serial Commands
113
SYSRESULT - System Check Result
This command reports the results of the system check.This command is reportable only.It cannot be
queried or set.
ARGUMENT DET
AILS
Name Type Size Values
System Check Hexadecimal Integer 2 06 – Remote (not implemented)
05 – Network
04 – Telephone
03 – Speaker
02 – Pod 3
01 – Pod 2
00 – Pod 1
All other bits reserved.
Status Unsigned Integer 2 0 = Fail
1 = Pass
Message String 40 For the pods:this message will say if a pod
is not connected. If a pod is connected, the
message will say which microphones fail. If
none fail,the message will say the pod
passes. For the speakers: the message will
say if the speakers fail.If they, pass but are
out of phase, the message will say they are
out of phase. Otherwise,the message will say
the speakers pass.
For the telephone on hook:the message will
report the line voltage,the line current,
other results,and if dial tone is detected.For
the telephone off hook:the message will
report the line current,other results, and if
dial tone is detected.The bit mask for the
other results is
For the network check:the box will report if
no IP address is set. If it is set, the box will
ping the gateway.The message will say the
ping failed if it is not returned in 5 s.
Otherwise, the message will report how
many seconds it took to return the ping.
BINARY FORM DETAILS
COMMAND ID
:88
NUMBER OF ARGUMENTS
:11
ARGUMENT FORM
: <System Check><Status><Message>
TEXT FORM DET
AILS
COMMAND FORM: DEVICE SYSRESULT <System Check> <Status> <Message>
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
Appendix — Serial Commands
112
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
STEREOMIX - Sets the Input to be a Stereo Mix
This command enables/disables or reports the stereo mix status of an input.
ARGUMENT DETAILS
Name Type Size Values Units
Channel Channel 1 See Group and Channels
Group Group 1 7 (L)
Value Unsigned Integer 2 0 = On
1 = Off
2 = Toggle
(NULL to query in text)
BINARY FORM DETAILS
COMMAND ID
:86
NUMBER OF ARGUMENTS
:1
ARGUMENT FORM
: <Channel><Group><Value>
TEXT FORM DETAILS
COMMAND FORM
: DEVICE STEREOMIX <Channel> [Value]
SYSCHECKS - System Checks
Initiates the system checks.There is no query for this command.
ARGUMENT DETAILS
Name Type Size Values Units
System Hexadecimal Integer 4 00 - Pod 1
01 - Pod 2
02 - Pod 3
03 - Speaker
04 - Telephone
05 - Network
06 - RF Remote (not implemented)
All other bits reserved
Check Integer
BINARY FORM DETAILS
COMMAND ID
:87
NUMBER OF ARGUMENTS
:1
ARGUMENT FORM
: <System Check>
TEXT FORM DET
AILS
COMMAND FORM
: DEVICE SYSCHECKS <System Check>
XXXXXXXX
set if switched from CTR21 to FCC because of low current
set if used DIAL bit while dialing
set if switch from Low Voltage to Japan because of current
set if switch from Low Voltage to FCC because of current
DAA OVL status
DAA DOD status
DAA OPD status
Not used