ClearSounds V608 Telephone User Manual


  Open as PDF
of 52
 
8 – ENGLISH
9 – ENGLISH
When the answering machine answers an incoming call, the caller
will hear your outgoing message. After a short beep they can then
leave a message up to 2 minutes.
Shouldthecallerexceedthislimit,thecallwillbedisconnected.
The memory will store approximately 14 minutes of incoming
messages(includingtheoutgoingmessage).
Voice Control
Theansweringmachinewillrecordamessageupto2minutes.If
the caller stops speaking, the answering machine will disconnect
afterapproximately7seconds.
Outgoing Message
Beforeyouusetheansweringmachineyoushouldrecordanoutgoing
message.Theoutgoingmessage isyourmessagetoan incoming
caller and may be up to 60 seconds in length.
You may want the message to tell the caller that they may start
speaking once the beep is heard.
Recording an Outgoing Message
1 Press and hold REPEAT. You will hear a short beep, and the display
willshow rA. (HoldtheREPEATkey downwhilerecording your
message)
2 Record youroutgoing message (min 5 seconds). Speak clearly
towardsthemachinefromadistanceof6-8inches.
3 Release REPEAT to stop recording.
4 The outgoing message will be repeated after a few seconds.
Repeat this procedure if you want to change the message, any old
outgoing message will automatically be erased when a new one is
recorded.
Checking the Outgoing Message
Press REPEAT.Thecurrentoutgoingmessagewillnowbeplayed.
PressON/OFFontheansweringmachine,tostopplayingtheOut
Going Message.
ANSWERING MACHINE SET-UP
Usethe2\6\TSswitchonthebottomofthephonetoselectafter
how many rings the unit will respond to an incoming call.
• 2=callsareansweredaftertworings.
• 6=callsareansweredaftersixrings.
• TS(TOLLSAVER)=activatesthetollsaverfunction.
Photo50-TriLingual.indd 8 7/6/08 11:11:12 AM
 previous next