ClearSounds V608 Telephone User Manual


  Open as PDF
of 52
 
10 – ENGLISH
11 – ENGLISH
Remote Code
Thisthree-digitremotecodeisrequiredinordertogainaccessto
theremotefunctionsoftheansweringmachine.Theremotecodeis
printed underneath the machine.
Remote Control
1 Call up the answering machine.
2 While the outgoing message is playing, enter the remote code. If
the code is accepted, you will hear two beeps.
3 Selectaremotecontrolcommand(within20seconds)frombelow.
4 When you have finished accessing the machine replace the handset.
Command Functions
25 ....................... Play new messages
2# ...................... Play all messages
During playback:
3# ...................... Erase single message during playback
6# ...................... Skip to previous message
7# ...................... Skiptonextmessage
8# ...................... Repeat message
## ..................... Stop playback
After playback:
3# ......................Erase all messages
7# ......................Record a new outgoing message, to Stop
recording press 7#again.
8# ......................Record a MEMO, to Stop recording press 8#
again.
9# ......................TurntheansweringmachineeitherOnorOff.
ThreebeepsindicateOff-TwobeepsindicateOn.
0# ......................Room monitor, press 5# to stop the room
monitoring.
NOTE: If the machine doesn’t respond correctly to the remote
control commands, try pressing the telephone buttons for a longer or
shorter time. In normal cases, the answering machine should react
to tones approximately 0.5 – 1 seconds in length, but longer tones
may be necessary. If you do not enter any remote control command,
the answering machine will disconnect after a few seconds.
If you listen to any incoming messages for more than 2 minutes and
Photo50-TriLingual.indd 11 7/6/08 11:11:12 AM
 previous next