Filter
Top Products
18
Using The Pause Feature For Dialing
The “R/P” button is used to insert a temporary pause during a dialing sequence. Program-
ming in a pause will cause the phone to wait two (2) seconds before dialing additional
numbers. This feature may be used when it is necessary to dial an access code (9, for
example) and wait for a second dial tone before you can dial an outside number. Press
the “R/P” button at the required point during the memory storage process to program a
pause.
When dialing an international number for example (i.e. 011-555-55-555-5555), some tele-
phone company systems will not register the entire number entry without a pause between
the prex numbers. You may have to dial 011- “R/P” button, dial 555- “R/P” button. This
allows adequate timing for the phone number to register with the telephone company’s
system and complete the call.
Using Line Transfer Feature
If extra handsets are set to the base unit:
1. During a phone conversation, press the “SEL” button and the handset number
you wish to transfer to. The line will be on HOLD and will make an audio sound
on the other handset.
2. On the other handset you can press to answer the call automatically after
receiving the transfer ring.
3. Press the button to return the connection back if the other handset user
does not want to take the call during the transfer ring.
4. If the two handsets do not respond within 60 seconds, the line will disconnect
automatically.
Using The Page / Handset Location Feature
Send a page signal from the base to the handset or to locate the handset.
1. Press the /PAGE button located on the base of the telephone to page the
handset.
2. Press the /PAGE button once more to cancel the paging feature.
3. If you do not press the /PAGE button again, the handset will ring for about
30 seconds then end the paging automatically.
Using The Headset Feature
You can use this telephone hands-free when you connect a 2.5mm headset (purchased
separately). To connect, plug the headset into the HEADSET JACK at the bottom of the
handset.
While in the Headset Mode, the volume of the headset is controlled by the telephone
and the handset’s earpiece and microphone are disconnected. Follow the procedures
discussed in ANSWERING A CALL and PLACING A CALL (See pages #17 & 18) when you
receive and place a call.