Filter
Top Products
42 43
Customer-Owned Coin/Credit Card
Phones:
To comply with state tariffs, the telephone company
must be given notification prior to connection. In
some states, the state public utility commission, pub-
lic service commission or corporation commission
must give prior approval of connection.
Part 15 of FCC Rules Information
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
Your equipment has been tested and found to
comply with the limits of a Class B digital device,
pursuant to Part 15 of FCC rules. These limits are
designed to provide reasonable protection against
harmful interference in residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in ac-
cordance with the instructions, may cause harmful in-
terference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation; if this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, you are encouraged to try to correct the
interference by one of the following measures:
1. Where it can be done safely, reorient the
receiving television or radio antenna.
2. To the extent possible, relocate the television,
radio or other receiver with respect to the
telephone equipment. (This increases the
separation between the telephone equipment
and the receiver.)
3. Connect the telephone equipment into an
outlet on a circuit different from that to which
the television, radio, or other receiver is
connected.
4. Consult the dealer or an experienced Radio/
TV Technician for help.
CAUTION: Changes or modifications not ex
-
pressly approved by the manufacturer responsible for
compliance could void the user’s authority to oper-
ate the equipment.
Industry Canada Technical Specifications
This product meets the applicable Industry Canada
technical specifications.
Before installing this equipment, users should ensure
that it is permissible to be connected to the facili-
ties of the local telecommunications company. The
equipment must also be installed using an acceptable
method of connection. In some cases, the company’s
inside wiring associated with a single line individual
service may be extended by means of a certified
connector assembly (telephone extension cord). The
customer should be aware that compliance with the
above conditions may not prevent degradation of
service in some situations. Repairs to certified equip-
ment should be made by an authorized Canadian
maintenance facility designated by the supplier.
Any repairs or alterations made by the user to this
equipment, or equipment malfunctions, may give the
telecommunications company cause to request the
user to disconnect the equipment.
Users should ensure for their own protection that
the electrical ground connections of the power util-
ity, telephone lines and internal metallic water pipe
system, if present, are connected together. This pre-
caution may be particularly important in rural areas.
REGULATORY COMPLIANCE REGULATORY COMPLIANCE