Filter
Top Products
4-5
Cisco Unified IP Phone 7960G/7940G Administration Guide for Cisco Unified Communications Manager 7.0 (SCCP)
OL-15498-01
Chapter 4 Configuring Network Settings on the Cisco Unified IP Phone
Network Configuration Menu
MAC Address Unique Media Access Control (MAC) address of the phone. Display only—cannot configure.
Host Name Unique host name that the DHCP server assigned to the
phone.
Display only—cannot configure.
Domain Name Name of the Domain Name System (DNS) domain in which
the phone resides. You can overwrite this value if the
Alternate Domain option is set to Yes.
1. Set the DHCP Enabled option to No.
2. Scroll to the Domain Name option,
press the Edit softkey, and then enter a
new domain name.
3. Press the Validat. softkey and then
press the Save softkey.
IP Address Internet Protocol (IP) address of the phone.
If you assign an IP address with this option, you must also
assign a subnet mask and default router. See the Subnet
Mask and Default Router options in this table.
1. Set the DHCP Enabled option to No.
2. Scroll to the IP Address option, press
the Edit softkey, and then enter a new IP
Address.
3. Press the Validat. softkey and then
press the Save softkey.
Subnet Mask Subnet mask used by the phone.
1. Set the DHCP Enabled option to No.
2. Scroll to the Subnet Mask option, press
the Edit softkey, and then enter a new
subnet mask.
3. Press the Validat. softkey and then
press the Save softkey.
TFTP Server 1 Primary Trivial File Transfer Protocol (TFTP) server used
by the phone. By default this server is CiscoCM1. If you are
not using DHCP in your network and you want to change
this default server, you must use the TFTP Server 1 option.
If you set the Alternate TFTP option to yes, you must enter
a non-zero value for the TFTP Server 1 option.
If the primary TFTP server is not listed in the CTL file on
the phone, you must unlock the CTL file before you can
save changes to the TFTP Server 1 option. In this case, the
phone will delete the CTL file when you save changes to the
TFTP Server 1 option.
For information about the CTL file, refer to Cisco Unified
Communications Manager Security Guide. For information
about unlocking the CTL file, see the “Security
Configuration Menu” section on page 6-12.
1. Set the Alternate TFTP option to Yes.
2. Scroll to the TFTP Server 1 option,
press the Edit softkey, and then enter a
new TFTP server IP address.
3. Press the Validate softkey, and then
press the Save softkey.
Table 4-2 Network Configuration Menu Options (continued)
Option Description To Change