Filter
Top Products
4-4
Cisco Unified IP Phone 7960G/7940G Administration Guide for Cisco Unified Communications Manager 7.0 (SCCP)
OL-15498-01
Chapter 4 Configuring Network Settings on the Cisco Unified IP Phone
Network Configuration Menu
Related Topics
• Displaying the Network Configuration Menu, page 4-1
• Unlocking and Locking Options, page 4-2
• Editing Values, page 4-3
• Network Configuration Menu, page 4-4
Network Configuration Menu
The Network Configuration menu contains options for viewing and making a variety of network settings.
Table 4-2 describes these options and, where applicable, explains how to change them.
For information about how to access the Network Configuration menu, see the “Displaying the Network
Configuration Menu” section on page 4-1.
Before you can change an option on this menu, you must unlock options as described in the “Unlocking
and Locking Options” section on page 4-2. The Edit, Yes , or No softkeys for changing network
configuration options appear on the Cisco Unified IP Phones 7960G/7940G only if options are unlocked.
For information about the keys you can use to edit options, see the “Editing Values” section on page 4-3.
IP settings If you do not use DHCP in your network, you can make IP settings
manually.
IP Address
Default Router 1-5
Subnet Mask
Domain Name
DNS Server 1-5
Port settings Allow you to set the speed and duplex of the network and access ports. SW Port Configuration
PC Port Configuration
TFTP settings If you do not use DHCP to direct the phone to a TFTP server, you must
manually assign a TFTP server. You can also assign an alternative
TFTP server to use instead of the one assigned by DHCP.
TFTP Server 1
Alternate TFTP Server
TFTP Server 2
VLAN settings Admin. VLAN ID allows you to change the administrative VLAN used
by the phone. PC VLAN allows the phone to interoperate with
third-party switches that do not support a voice VLAN.
Admin. VLAN ID
PC VLAN
Table 4-1 Settings Configurable from the Network Configuration Menu
Category Description
Network Configuration
Menu Option
Table 4-2 Network Configuration Menu Options
Option Description To Change
DHCP Server IP address of the Dynamic Host Configuration Protocol
(DHCP) server from which the phone obtains its IP address.
Display only—cannot configure.
BOOTP Server Indicates whether the phone obtains its configuration from
a Bootstrap Protocol (BootP) server instead of from a
DHCP server.
Display only—cannot configure.