Filter
Top Products
Channel “A” Button
Channel “B” Button
The two headsets in your retail box are already factory paired and
ready to use. Unless you wish to add additional bikers for a 3-way
or 4-way call, you can skip the following explanation and proceed
directly to section 9.4
Read the following if you want to set up 3-way or 4-way calls and/or if
you wish to pair your headset(s) with earlier scala rider models:
Since the scala rider G4 can be paired with all models among the
scala rider family, we recommend that you rst pair it according to
your preferred conguration and then change or modify as often as
you wish later as the need arises. For example: If you typically use the
intercom to communicate with two friends who both use G4 units,
then you should pair it as described below in section 9.10 b.
Therefore, please select your initial pairing preference now amongst
the following options in the table below and following that, refer to
the pairing procedure as described in the respective section of this
manual. When done, return to the explanations in section 9.4 “Initi-
ate Intercom Calls”.
Select your preferred Pairing Option
HEADSETS TO BE PAIRED
GO TO
SECTION
Your G4 with another G4 9.10 a
Your G4 with a Q2 9.11 a
Your G4 with one earlier scala rider model 9.11 b
HEADSETS TO BE PAIRED
GO TO
SECTION
Your G4 with a third G4 unit 9.10 b
Your G4 with one G4 and one Q2 unit 9.11 c
Your G4 with two Q2 units 9.11 c
Your G4 with one G4 and one other scala rider model 9.11 c
Your G4 with one Q2 and one other scala rider model 9.11 c
Your G4 with two other scala rider models 9.11 c
Your G4 as part of 4-Way intercom call conguration 9.10 c
9.4 INITIATE INTERCOM CALLS
There are two ways to start an Intercom call with headsets that are paired
to your scala rider G4 (make sure you are in Standby mode):
VOICE CONNECT:
Preferred for relatively brief conversations
as it takes the channel into standby mode
after 30 seconds of silence
Start talking loudly
Once you start talking loudly, an Inter-
com call will be established with both
paired headsets, CHANNEL “A” and
CHANNEL “B” (if both are available).
The Intercom call will stay on until all
participants remain silent for 30 seconds
(Applicable for 2-way communication).
CHANNEL BUTTON CONNECT:
Preferred for extended conversa-
tions as it leaves the channel open
and active
Single tap the CHANNEL “A”
Button to add or remove the
CHANNEL “A” headset from an
Intercom call.
Single tap the CHANNEL “B”
Button to add or remove the
CHANNEL “B” headset from an
intercom call.
NOTE: While the Intercom is on, the Redial and Voice Dial functions will be
disabled.
9.5 RECEIVING INTERCOM CALLS
Once another paired headset tries calling you via intercom, the call
will begin almost instantly.
14
scala rider
®
G4
™
PowerSet