Filter
Top Products
Engli sh
STATUS LIGHTS
LED Indication Status
None Headset is o
1 blue ash every 3 seconds Standby – No call is in progress
2 blue ashes every 3 seconds Audio active
1 red ash every 3 seconds Standby - Battery is low
2 red ashes every 3 seconds Low battery while audio is active
Solid red Charging
9. USING THE INTERCOM
9.1 INTRODUCTION
Flip-up Antenna
for extended range
The scala rider PowerSet provides you with an impressive Bike-to-
Bike Intercom range by simply ipping
up the antenna. The ip-up antenna
allows you to maximize the intercom
range with other bikers at up to 1 mile /
1.6 km (subject to terrain). The antenna is
also useful when riding in dense urban
environments that may aect the
transmission quality. You may keep the
ip-up antenna open when not using
the intercom, even though there is no particular need to do so.
The scala rider G4 PowerSet package contains two factory paired
G4 headsets. To set up additional Intercom Bluetooth connections,
you must rst pair your G4 headset with the other headsets.
Pairing is a one time process. Once completed, the headsets will
remain paired and automatically recognize each other whenever they
are within range.
For details on Intercom use with other scala rider headsets, please refer to
section 9.11 below
Your headset has two Intercom channels available for headset-
to-headset connections. Therefore, your G4 can communicate
simultaneously with up to two other headsets. If one of these
other headsets is connected to yet another G4 headset, then all
four participants can enter into a 4-way conference mode (see
section 9.10c below).
9.2 BACKWARDS COMPATIBILITY
Your scala rider G4 can also conduct Intercom communications with
earlier scala rider models in dierent congurations and you can
always change your preferences.
There are four other scala rider models available that your G4 can
connect to, and each of these connections comes with specic char-
acteristics and / or limitations.
In terms of range, Intercom communications between your G4 and
another scala rider unit is limited to the distance of the lesser-range
device. For example, connecting your G4 with a Q2 unit will enable
intercom distances of up to 500 m / 540 yards, which is the maximum
rated distance the Q2 can achieve.
In the section below you can nd out how to pair your G4 with
other scala rider models, such as the “Q2™”, “Solo™ “, “FM™ “, or a
Driver unit of the “TeamSet™”. In addition, your headsets are also
fully compatible with the Schuberth SRC-System™. For details, visit
www.cardosystems.com/src.
9.3 BEFORE STARTING THE INTERCOM
Your scala rider G4 headset has two buttons designated for quick
connection to two other headsets. These other headsets are referred
to as CHANNEL “A” and CHANNEL “B”. In the following sections
you will also learn how to add a third participant and conduct an
intercom conference mode.
13
scala rider
®
G4
™
PowerSet