Filter
Top Products
Synergy 3200 SMS user guide ~ 4th Edition ~ 16th October ’02 ~ 4678
38
No display appears.
No dial tone.
You cannot link up with the
base station.
No ring on the handset.
Buzzing noise on my radio, TV,
computer or hearing aid.
The base station is not charging
the handset
The batteries may be flat or dead.
The handset may be switched off.
The telephone line cord may not
be plugged into the phone socket
or the base station may not be
connected to the power supply.
The base station may not be
connected to the power supply.
Is the display flashing ?
You are out of range of the base.
The batteries could be low or flat.
Your handset could be registered to
the wrong base.
The ringer volume may be
switched off.
Base station may not be properly
connected.
Sometimes, your Synergy 3200 SMS
can interfere with other electrical
equipment if it is placed too close.
Power adaptor might not be properly
plugged into the base station.
You could be using the wrong power
adaptor.
The handset might not be in the
charger correctly.
The batteries may not be fitted
correctly.
Recharge or replace the batteries.
Switch the handset on, see page 14.
Check that the telephone line cord
is plugged in and that the base
station is connected to the mains
power and is switched on.
Check that the mains power cable is
connected at the base and switched on.
Move closer to the base station.
Charge the handset batteries or
replace them if necessary.
If using more than one base station,
check that you are connected to the
correct base. See page 26.
To adjust the ringer volume on the
handset. See page 21.
Check that the base station is
plugged into the phone socket and
that the base station is plugged into
the mains power and switched on.
It is recommended that you place
your Synergy 3200 SMS and other
Synergy/ DECT GAP compatible
handsets at least one metre away
from such appliances to avoid any
risk of interference.
Check that the base station is
plugged into the mains socket and
switched on.
Check you are using the correct
power adaptor, item code 872260.
Check that your handset has slotted
correctly into the base station
charger.
Make sure the batteries are
correctly fitted into the handset.
Telephone problems Possible cause Solution
HELP