Filter
Top Products
28
Synergy 2110 - Edition 5 – 23rd October ’00 (3375)
Your Synergy 2110 is preset
to TONE dialling. On some
switchboards it may be
necessary to change the
dialling mode to PULSE.
Press the Options button,
then the 0 button. You will
hear a confirmation tone.
PIN Enter the 4-digit base station
PIN. Original setting 0000.
Press the Options button to
confirm.
Press the 1 button, then
press either 1 for TONE or
2 for PULSE dialling.
Press the Options button to
confirm.
Press to return to
standby.
Dialling mode
Options
R
Please note
Some switchboards may require you
to switch from Tone to Pulse dialling.
Go to Tone
Operation of your keypad
after this will now be in
TONE mode. When the call
is completed your Synergy
2110 will automatically revert
to PULSE dialling.
To adjust Recall settings
The R button is used to
access switchboard services
(and also some BT Select
Services). In order for the R
button to work correctly with
some switchboards it may
be necessary to change the
timing of the recall signal.
The original setting is 100ms.
Press the Options button.
Press 0.
PIN
Enter the current PIN.
(Original setting = 0000.)
Press the Options button.
Press 4.
Enter the setting required
for your switchboard:
1 = 80ms
2 = 100ms
3 = 130ms
4 = 250ms.
Press the Options button to
confirm.
Press the button to
return to standby.
Options
R
Options
R
Options
R
0
&
.
/
4
G
H
I
1
+
–
2
A
B
C
3
D
E
F
4
G
H
I
Options
R
Options
R
0
&
.
/
1
+
–
If you are in the PULSE
dialling mode then certain
services accessed by tone
dialling are not available.
During the call you can
change to TONE by pressing
the
✱
button until you hear a
confirmation tone.
GENERAL INFORMATION