Filter
Top Products
Synergy 2110 - Edition 5 – 23rd October ’00 (3375)
21
Using additional handsets
Registering an additional Synergy handset with the base station
or de-registering a handset.
As well as your original handset,
you can register up to a further 4
additional handsets to your Synergy
2110 base station.
The system allows internal calls
between two handsets while a third is
making an external call.
Each additional handset you purchase
must be registered to the base station.
Please note
Remember to charge the batteries of
new handsets for at least 16 hours.
When switched on, a new additional
handset will display the flashing
icon.This tells you that the handset is
not yet registered with the base station.
At the base station:
Press and hold the Page
button for at least 10 seconds.
The green Power/In Use light
will flash.
At the handset:
Within the next 30 seconds
press the Options button.
Press the 5 button.
Enter the number of the base
station you wish to register
the handset to (1-4).
For example, if it is the
second base station you are
registering a handset to you
should use 2 and so on.
You will hear a confirmation
tone.
Enter your base station PIN.
(Original setting = 0000.)
Press the Options button to
confirm.
To register a handset
Please note
If the registration process fails, the
handset display shows the flashing
icon and you should begin the process
again.
Please note
The following process is only for
registering another Synergy 2110
handset to the base station.
If you are registering any other handset,
then please refer to that handset’s user
guide for instructions.
Page
Options
R
5
J
K
L
Options
R
1-4
PIN
ADDITIONAL HANDSETS