Filter
Top Products
Battery levels
0-50% 50-100% 100%
flashing
Synergy 2110 - Edition 5 – 23rd October ’00 (3375)
9
Battery performance
To keep your battery in the best
condition, leave the handset off the
base station for a few hours at a time
(after the initial 16 hour charge).
After charging your Synergy handset
for the first time, subsequent charging
time for the battery is approximately
4-5 hours. Battery and case may
become warm during charging.
This is normal and not dangerous.
Under ideal conditions, the handset
battery should give about 6 hours
talktime or 100 hours standby on a
single charge.
Please note, however, that a new
Nickel Cadmium(Ni-Cd) battery does
not reach its full capacity until it has
been in normal use for several days.
Fully discharging the batteries at
least once a week will help them to
last as long as possible. However,
the charge capacity of rechargeable
batteries will reduce with time as
they wear out, so reducing the
talk/standby time of the handset.
Eventually they will need to be
replaced.
Battery low warning.
If the handset battery symbol is
empty and flashing, and you hear
a warning beep every 10 seconds,
you will need to recharge your
handset before you can use it.
3
Charge the handset battery
for at least 16 hours
Before you use your Synergy 2110 for
the first time, it is important to have
the handset battery fully charged. We
recommend that you leave the Synergy
2110 on charge for at least 16 hours.
Under no circumstances should
non-rechargeable batteries be used.
Only use the approved batteries.
Using unapproved batteries will
invalidate your guarantee and may
damage the telephone.
Place the handset on the base. The red
charging light comes on. The handset
should come pre-registered to the base
station as 1 and this is shown in the top
right corner of the display.
The battery symbol is also shown.
It flashes during charging. Once the
handset is fully charged, the display
shows a full battery symbol.
SETTING UP
The Synergy 2110 uses a Nickel
Cadmium(Ni-Cd) battery pack supplied.
Take care to connect the battery as
shown and replace the battery cover.
2
Install the rechargeable
battery in the handset