BT 3010 Cordless Telephone User Manual


 
8
Place the handset on the base.
When charging, the battery level
symbol shown on the display flashes.
Battery performance
After charging your Diverse 3010 Micro
for the first time, subsequent charging time
for the handset batteries is approximately
4-5 hours. The battery pack and case may
become warm during charging. This is
normal and not dangerous.
Note
Under ideal conditions, the handset
battery should give about 15 hours
talktime or 200 hours standby on a single
charge. However, new NiMH batteries do
not reach their full capacity until they
have been in normal use for several days.
Please note that the lifespan of NiMH
rechargeable batteries depends on how
heavily they are used. However, over time,
their capacity to recharge will begin to
diminish and they will eventually need
replacing.
Battery low warning
An LCD on the handset display shows the
current state of the charge. When the
battery is almost flat a beep sounds and
the display shows the empty battery symbol.
Displays showing the various states of
charge are shown below:
Batteries fully charged
Batteries at 66%
Batteries at 33%
Batteries empty
If e.g Base 1, flashes continuously
It means the handset is either out of range
or is not registered with the base station.
To register, follow the steps on page 46.
All additional handsets you purchase will
need to be individually registered with the
base station before they will work with the
Diverse 3010 Micro.
The base number may also flash after a
power failure. Provided the handset has
been registered with the base, the base
number will stop flashing after a while
indicating the handset has automatically
re-registered to the base station. If it
continues to flash, re-register the handset
to the base station.
SETTING UP