BT 3010 Cordless Telephone User Manual


 
3 Install the rechargeable
battery pack in the handset
The handset uses a rechargeable Nickel
Metal Hydride (NiMH) battery pack,
which is supplied. You must only use
approved batteries. To install it, insert
the battery pack as indicated on the
label inside the battery compartment
and slide the battery compartment
cover shut. The battery compartment
cover may be found in the packaging
with the batteries.
To fit the battery into the handset.
1. Remove the belt clip from the back
of the handset.
2. Slide the battery cover off in a
downward movement.
3. Plug in the battery connector.
4. Insert the battery pack ensuring
that the wires are stored beneath
the battery pack.
Slide the battery cover back on.
7
Tab
Slot
4 Fit the handset belt clip
Fit the belt clip onto the back of the
handset.
5 Charge the handset
batteries for at least
16 hours
When charging for the first
time, we recommend that
you let the batteries charge
for the full 16 hours.
Battery display when inserting
or replacing a battery pack
When you replace the handset battery
pack with one that has been fully charged,
the battery indicator will not show full
until the next charge cycle has been
completed. Charge the handset until the
battery register full again. From then on
the display will be correct.
2
1
3
4
SETTING UP