Filter
Top Products
38
Baby Alarm
To switch the baby alarm ON and OFF
The baby alarm sets up a connection
between two handsets registered to the
same base. When a noise registers in the
first handset, the second handset rings.
If the call to the second handset is
answered, conversation is possible. The
default setting for this service is OFF.
The baby alarm will not work in
conjunction with call barring. For the
baby alarm to work properly, all handset
batteries must be fully charged and the
handset in the ‘baby room’ must not be
placed in a charger, as this will cover the
microphone.
Ensure that the handset in the ‘baby
room’ is out of reach of the baby, (due
to the small and sharp parts that are
present).
On the handset in the ‘baby room’:
• Press the
MENU button.
• Select
BABY ALARM.
• Press
OK.
• Enter the extension number of the
handset you want to ring as the alarm.
-
-
–
–
–
–
–
RED
OK
WARNING
Please note that the Baby Alarm
does not provide continuous
monitoring but is activated only by
noises over a certain volume.
It should therefore only be used as
a support to your existing baby
monitoring system and NOT as an
alternative.